| |
LED Flood light Series |
LED Flood light
Single Color adopts 1W high power LED as its luminous body, which is of high brightness, stable
performance, long longevity and low power consumption. The input voltage is 110VAC or 220VAC. Its current is
stable ensured by high efficient and wide voltage constant current driver.
With aluminum housing and 5mm high transparent toughened glass surface, it can achieve protection class IP65.
Special aluminum heatsink contacts the PCB board so closely that it shortens the path of heat-sinking to ensure
longer life of the product.
Ventilation condition is needed for the application, or heat-sinking device should be used. This product can be
installed very conveniently by using matched aluminum mounting base and the light direction can be adjusted at
will. It can be widely used for partial lighting, indirect lighting, spot and flood lighting, etc.
|
1.Picture: |
LED flood light Drawing |
|
2.Feature: |
|
|
|
LED Flood lightTechnical Parameters:
Color range – Different brightness of red, green & blue
LEDs, combine to produce 16,000,000 colors.
Light source – 1W High Power LEDs
LED color/Quantity – Red12, Green 12, Blue 12
Beam angle – 25/45°
Light spacing – 20M
Digital interface – Standard DMX compatible
Controlling system – DMX512
DMX address – Generated by digital pipeline
Housing material – Aluminum alloy
Connecting mode – Standard signal cord
Connector – 3-pin signal connector
Electrical specification:
Operating voltage – AC90-264V/24V
Operating current – Max.2A
Power consumption – 48Watts
Protection rating – IP65
Environmental specification
Operating temperature: -20°C to 40°C (using the
industrial components)
Size – L320*W145*H225
Weight – 3.9Kgs (8.6lbs.)
Color effects
Static display – Static display of 16,000,000 colors by
mixing colors
Flashing change – Colors transition from high
brightness to low brightness
Cross fade – Colors alternate
Chasing change – Colors chase one another
Flowing function – Single color flowing regularly
|
Round LED Flood light 18W |
|
|
|
| Round LED Flood light 36W |
|
|
|
Square LED Flood light 18W |
|
|
|
| Square LED Flood light 36W |
|
| |
 |
| 3.LED Flood light connection: |
 |
| 4.Project foto: |
  |
| 5.Connection: |
| Connect the input connector of the first fixture to the output connector of the DMX console; connec
the output connector of first fixture to the input connector of the second fixture; etc., as shown in
following diagram.
1) Put the output connector of the first fixture into a Φ20 thermal shrinking sleeve with glue inside
The end of the sleeve should be 40mm from the joint of the cable and the connector.
2) Put the input connector of the second fixture into theΦ20 thermal shrinking sleeve so as to
connect it with the output connector of the first fixture.
3) Blow and shrink the sleeve ends with a hair drier so that the sleeve and the signal cable are
tightly contacted for waterproof purpose.
The signal output connector of the last fixture (maximum 30 fixtures) of each series must be sealed with aΦ20
thermal shrinking sleeve and blow and shrink it with a hair drier for waterproof purpose.
 |
|